Arduino Push Button in proteus Simulation
Arduino Push Button in proteus Simulation Here’s the Arduino code for lighting up an LED when a button is pressed twice. It uses a button press counter to detect two consecutive presses, with a debounce mechanism to ensure reliability. Components needed: An Arduino board, like the Uno or Nano. A pushbutton. An LED of any color. A 220-ohm resistor for the LED. (if you are doing the hardware version of the project) A breadboard and some jumper wires. (if you are doing the hardware version of the project) And, of course, a USB cable to connect your Arduino to your computer." (if you are doing the hardware version of the project) Circuit Diagram in Proteus Below is the Arduino Code: const int buttonPin = 2; // Button connected to pin 2 const int ledPin = 13; // LED connected to pin 13 int butto...